Akai MPC Manuel de l'opérateur télécharger pdf (Page 4)

READ THIS BEFORE YOU START!

Power requirements

Power requirements for electrical equipment differ from area to area. The

operating voltage of this machine is preset at the factory according to its

intended destination. However, some models are equipped with a voltage

selector. If your machine is so equipped, before connecting, check to see

that the VOLTAGE SELECTOR on the rear panel is set to the voltage

for your area. If not, please set it correctly before plugging in the

power cord:

220V, 50 Hz for Europe except UK.

240V, 50 Hz for UK and Australia.

120V, 60 Hz for U.S.A. and Canada.

If the VOLTAGE SELECTOR on your machine looks like this: If the

VOLTAGE SELECTOR on your MPC60 looks like the diagram on

the right, please disconnect the power cord, then set the switch to the

correct voltage for your area, using a flat screwdriver.

What you should know to protect yourself and the Akai

MPC60:

Watch out! You might get an electric shock.

• Never touch the power plug with wet hands.

• Always pull out the power plug by the plug and never the cord.

• Only let a qualified professional repair or reassemble the Akai MPC60. An

unauthorized person might touch the internal parts and receive a serious

electric shock.

• Never allow a child to put anything, especially metal, into the Akai

MPC60.

Let's protect the Akai MPC60 too.

• Use only a household AC power source. Never use a DC power

source.

• If water is spilled on the Akai MPC60, disconnect the power and call

your dealer.

• Make sure that the Akai MPC60 is well ventilated and away from direct

sunlight.

• To avoid damage to the internal circuits and the external surface, keep

away from heat (stoves, etc.)

1 2 3 4 5 6 7 8 9 ... 227 228

Pas de commentaire

Akai MPC Manuel de l'opérateur Page 4