MVP MANUAL
8. DEMO PATTERN SETTINGS AND CAUTIONS
The MVP does not have an RMD-V3216 type DEMO switch, but 2x2 enlarged screen automatic display is pos
sible by reading the input selector switch (OPTION/V IN) when the power is turned on and executing the com
mand corresponding to that setting.
Because of this, upon shipment from the factory command examples for displaying the MVP 2x2 enlarged
screens have been written into the demonstration switch No. 8 and No. 9 areas, which were user program areas
on the RMD-V3216.
Switch No. 8 contains the command example for displaying 2x2 enlarged screens for the OPTION input picture
(A input).
Switch No. 9 contains the command example for displaying 2x2 enlarged screens for the V IN input picture (C
input).
2x2 enlarged screens may not be displayed if the contents of demo No. 8 and demo No. 9 are replaced. If this
happens, reset the factory defaults.
The commands written into the set upon shipment from the factory and the procedure for writing the com
mands are described below.
!
&NO011
&NO121
&NO212
&NO322
[8
W3
M11A22
]
[9
W3
M11C12
]
Start the command interpreter and input the following commands.
Matrix screen number setting . . . . . . . . . Set VOUT1 matrix coordinate to 11.
Matrix screen number setting
. . . . . .
Set VOUT2 matrix coordinate to 21.
Matrix screen number setting
. . . . . .
Set VOUT3 matrix coordinate to 12.
Matrix screen number setting
. . . . . .
Set VOUT4 matrix coordinate to 22.
Write in the command example for 2x2 enlargement of the A input to demonstration switch No.
8.
: Write in the command example for 2x2 enlargement of the C input to demonstration switch No. 9.
End.
The RM-V1000NU's internal MVP assembly (AWU1014-) uses slots A and B, but this set uses slots A and C.
Note that because of this the M command setting is different.
157
Commentaires sur ces manuels