Akai CD3000XL Manuel de l'opérateur télécharger pdf (Page 70)

EDIT PROGRAM - SINGLE

Page 64 S3000XL Operator’s Manual

MIDI PAGE

Pressing displays this screen:

The top line of this page contains a field which allows you to change the program currently

being edited. You may select different programs for editing here if you wish.

The parameters on this page are as follows:

This field allows you to set the program number of the program.

This is the number which will be called up on receipt of a MIDI

Program Change message and corresponds to a patch number

on a synthesiser.

This parameter selects the program's MIDI channel! The choice is

OM (omni) and 1 to 16.

This allows you to select how many notes (1 to 32) can be played

at a time by this particular program. This should normally be left at

the default, 32.

NOTE: This parameter should normally be set to the default of 32. Its inclusion here is

mostly for historical purposes. On the S1000/S1100 (and early versions of software for the

S2800, S3000 and S3200), it was common to use this parameter for hi-hats and the like

layered over a drums program (i.e. the hi-hats would be set to a polyphony of 1 voice so

that the closed hi-hat shut off the open hi-hat). With the MUTE GROUP function, however

(see later in this section), this parameter is not used so much but is retained should you

load an old S1000/S1100 or early S2800, S3000 or S3200 sound library disk.

See below for a description of the MUTE GROUP function.

This allows you to specify how notes will be 'stolen' by other

programs if this is necessary. There are four settings: LOW,

NORM, HIGH and HOLD. If a program is set to LOW priority, then

notes from this program will be stolen first. If set to HIGH, then

notes from other programs with lower priority will be stolen before

they are stolen from this program. NORM is, of course, normal

priority and, if any note stealing has to take place, this program will

be affected no more or less than others with NORM assignment.

If you are playing a complex piece of music using many programs,

it is a good idea to set important, lead-line sounds to HIGH, and

less important background programs to LOW.

HOLD is a special priority. If a program’s priority is set to HOLD,

notes from this program can only be stolen by the same program.

The notes which will be stolen are determined by this parameter -

either the OLDEST note will stop playing when a note is stolen or

the QUIETEST one.

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 312 313

Pas de commentaire

Akai CD3000XL Manuel de l'opérateur Page 70