Akai MPC Manuel de l'opérateur télécharger pdf (Page 86)

MPC500 Operator's Manual rev 1.0

off will be set higher and more of the high frequencies will be let through the filter, resulting in a brighter sound. If you set this field to 0,

the sample will always sound bright.

Voice Overlap

Normally, when you hit the same pad several times, the same sound will be overlapped. When you use the MPC500 as a drum machine,

you can make the performance sound natural with this feature. However, when you are using a phrase sample, it may be better not to

overlap the same sound. With the voice overlap function, you can set the MPC500 not to overlap the same pad sound.

1. While in PROGRAM mode, hit the pad you wish to edit.

The pad number display in the 'Pad' field will change according to the pad you hit.

2. In the 'Edit select' field, scroll to 'Voice overlap'.

3. In the 'Parameter' field below, select from one of the choices below:

POLY - The MPC500 overlaps the sound.

MONO - The MPC500 does not overlap the sound

If you select MONO, when you hit the pad several times, the sample will play up until you hit the pad again. This can create a 'stutter'

effect.

Setting the Mute Group

Normally, when you hit a pad when another pad is played back, the samples of these two pads will be played back overlapped. With the

mute group function, you can stop the playback of the sample of a pad when you hit another pad. You can simulate the open/close hi-hat;

the sound of the close hi-hat will stop when the open hi-hat sound is triggered. You can use this function by setting two pads to the same

mute group. The pads set to the same mute group will not be played at the same time.

1. While in PROGRAM mode, hit the pad you wish to edit.

The pad number display in the 'Pad' field will change according to the pad you hit.

2. In the 'Edit select' field, scroll to Mute group.

3. Select a pads to set to the mute group, by hitting the pad.

4. In the 'Mute group' field, select a number. Set the Mute group 'Parameter' field to On.

5. Select the other pad to set the mute group, by hitting the pad. Set the Mute group 'Parameter' field to On.

6. Hit one pad while playing back another. The first sample will be stopped and only the sample of the pad you hit last

will by played.

Tip: You can set the mute group to more than two pads.

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 119 120

Pas de commentaire

Akai MPC Manuel de l'opérateur Page 86