Akai MPC 60 Manuel de l'opérateur télécharger pdf (Page 182)

Chapter 9: Saving and Loading From Disk

Page 176

Loading a PAR File (System Parameters)

If a PAR file is selected for loading in the Load File screen and <Load it>

is pressed, a screen will appear warning you that all existing system

parameters in memory will be erased. To load the file, press <Load it> in

that screen.

Files That Automatically Load on Power-Up

If a disk is in the drive when power is turned on, the MPC60 will load

from the disk the first APS (all programs and sounds) file that it finds,

including all sound files used by the APS file. If more than one APS file

exists on the disk, the first one found will be loaded. If no APS files exist

on the disk, up to 8 PGM (program) files will then be loaded into

consecutive program numbers (including all sound files used by the

PGM files). Next, the first ALL file (all sequences and songs) that is

found will be loaded.

To cause specific programs, sounds, sequences, and songs to load

automatically when power is turned on, save a single APS file to a disk

that contains the desired programs and sounds, then save an ALL file

that contains the appropriate sequences and songs to the same disk.

Insert this disk in the drive and turn the power on—the APS and ALL files

will load automatically.

If you have Marion System MPC-SCSI interface installed and a SCSI

hard disk connected, and no floppy disk is in the drive when power is

turned on, the MPC60 will load the following files from partition A of the

hard disk automatically: STARTUP.APS (and all sound files used by that

file) and STARTUP.ALL.

1 2 ... 177 178 179 180 181 182 183 184 185 186 187 ... 240 241

Pas de commentaire

Akai MPC 60 Manuel de l'opérateur Page 182