Akai RE32 Manuel de l'opérateur télécharger pdf (Page 106)

96 Version 1.00

EDIT TOOLS

Pressing XFADE (F1) on the CROSSFADE TOOLS page takes you to this screen:

The parameters are:

AMOUNT The amount by which the two cues are to overlap.

METHOD The method by which the overlap is to be achieved (TRIM or SLIP) and

may be selected either using the DATA ENTRY +/- keys or more directly

using F1 and F2.

When TRIM is selected, one or both of the cues will be extended; this

assumes that the cue in question has a handle available for extension.

Note that the targeted cue turns yellow, while the passive cue stays

green.

With SLIP selected, either the PRE or the POST cue (not BOTH) is

actually moved along the timeline. SLIP IN can also be selected from

within the TRIM page by pressing the IN key while pressing SHIFT.

Similarly, OUT + SHIFT selects SLIP OUT.

SLIP mode is clearly dangerous if working to picture, hence the cues in

question turn red in warning. Note that, when SLIP is selected F3

becomes active as SLIP? and toggles between slipping just the cue or

the entire track:

ADJUST Selects which point(s) is to be adjusted:

PRE (F4) Selects the PRE point for adjustment.

POST (F5) Selects the POST point for adjustment.

BOTH (F6) Selects both PRE and POST points for adjustment.

Having set the required parameters, press the EXECUTE key to proceed.

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 191 192

Pas de commentaire

Akai RE32 Manuel de l'opérateur Page 106