Akai RE32 Manuel de l'opérateur télécharger pdf (Page 37)

Version 1.00 27

GETTING STARTED

NOTE 1: This page will only allow selection of sample rates that are supported on all the

connected machines.

NOTE 2: Recordings made at a sample rate other than the selected sample rate will play back

at the wrong speed. For example, if the sample rate is set to 44.1kHz and you try to play back

a recording made at 48kHz, the recording will play back slow. Therefore, please make sure

that your recordings are made at the correct sampling rate. Recordings made at different

sample rates cannot be used in the same project.

TC FRAME RATE This shows the system’s timecode rate.

This field is not editable, but instead serves as a visual check that all

machines are configured correctly. If all machines are set to the same

frame rate, then this rate will be displayed here. If not, this field will say

“* DO NOT MATCH *”.

Timecode frame rates can be individually set on each machine as

explained later in the section on TIMECODE SETUP.

The SETUP page’s soft keys take you to other pages where certain parameters that affect the

whole unit may be set. Not all of these are relevant for basic operation so, for the moment, we will

continue looking at other modes that are necessary for basic operation.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 191 192

Pas de commentaire

Akai RE32 Manuel de l'opérateur Page 37